Talk about the purchase method of tripod
Seven mouth eight tongue: talk about the purchase method of tripod
[Hailong Information Report] There is a tripod, no matter how small aperture, how slowly, the speed can take a clear photo, and don't have to worry about the image of the camera vibration. In a studio, you can use the maximum and most important tripod to achieve the most solid support. When traveling and taken long, you need to take light and convenient to carry. However, it may not be stable enough when supporting long lenses. In addition, large super-weight tripods may also be low in use, and most of the time is bundled. When you buy a tripod, you should compare several brands according to the stability, mainly consider the following points:
(1) The tripod of the three-piece side feet is often stable than the four-stage tripod;
(2) The fastener made of tubular metal is more securely made than the U-shaped groove metal, of course, with the advancement of technology, high hardness of carbon fibers, is also applied to tripod;
(3) Outdoor photography, there is a tip-convex tripod at the end of the side feet, and there is a good grip on the soft ground; however, the tip must be detachable to use in indoor or hard.
(4) It is preferred to have a button each side feet to control the angle of the side pin, which is useless;
(5) The side lock can prevent the side foot. The most easily used is the buckle, and the buckle is clamped. Tighten with twisting locks is also relatively firm;
Many tripods have a cloud to Taiwan, but not necessarily. There are two three knobs to adjust the camera up and down, and the left and right shooting angles is the most common form. However, this cloud can operate very convenient, then you can choose a spherical cloud, just rely on a knob, you can adjust the camera's shooting angle, convenient. Some PTZ also accompanied by a tension button to increase the tightness of the bearing. When using the heavy lens, the rotating button is pre-tightened, even if it is unintentionally relaxed, the heavy lens will only slow down, and it is not heavy to on the trip.
Many styles of tripods have a fast disassembly device on the stand, which is convenient for the camera or lens. It consists of a flat panel that is joined to the camera (or telephoto lens) and a buckle on the pedestal base, which is convenient than the conventional base to be rotated and tightened.
When shooting a moving subject, the convenience of the camera movement may be more important than the stability of the operation platform. At this time, the weight, the convenient single-legged, is a relatively suitable support tool, and will stand a single foot On a sturdy object, it is most secure.
In order to ensure the stability of the support, the side feet of the tripod, especially the central axis, not very necessary, should not extend too long, the wind is particularly paying attention to.
In short, when buying tripods, pay attention to the above suggestions, more than different brands, different styles, according to their own needs, select the most firm, operate the most convenient and reliable steps. Using tripods is one of the important steps of amateur transition to professional photography, at least from technology (non-creative), allowing photos to achieve higher levels.
Net weight (G): 1950 Maximum Work Height (mm): 1650 Continue Height (mm): 680 Minimum Work Height (mm): 630 Maximum Pipe (MM): 28.2 × 22.2 Maximum Load (KG): 4 Features: 3D PTZ, 360 ° rotation, detonable panel, rocker lifting, weightless hi-homotropic fastener TR260 net weight (G): 1730 maximum working height (mm): 1610 Continue height (mm): 690 Minimum working height (mm) : 650 Maximum Pipe (MM): 36 × 19.5 (Ellipse) Maximum Load (Kg): 3.5 Features: 90 ° Side Take, Rocker Lifting, Power Travel
[Repost] DC tripod full introduction Digital camera Best partner - can not ignore tripod purchase 〖Original〗 Wear Xi'an - Gao Chenguang Beijing Reprinted 2004 February 07 10:45 [Introduction to the reading] Reading people due to consumer electronics The popularity of the popularity, the price of digital cameras (DC) has become very popular, so there is a lot of amateur photography enthusiasts that have DC ... (3886 words) Due to the popularity of consumer electronics, the price of digital cameras (DC) has already Very popular, so there is more amateur photographers with DC. Of course, this kind of amateur photography enthusiasts and traditional photography enthusiasts still have a different difference. After all, use DC photography than a single-inverse machine, or let many friends who don't understand photography can come up. However, many friends often take some blurred photos with DC photography, usually the user think is that the focus is not allowed or the camera is jitter. But very few friends can pay attention to the role of tripods on the quality of shooting, and that the tripod is mostly the equipment of professional photographers or Selfie, and the emphasis on the tripod is reduced. However, we are not to discuss the importance of tripods on photography, but to discuss the purchase of tripods. The general alloy portable tripod, representing the brand for the Weifeng series tripod is used to do? Many friends will purchase a tripod when new to buy cameras. However, it is not easy to choose a good corner. The current fractal price is not equal to a few hundred yuan to a few thousand yuan. Do not think that the function of the tripod is simple, because a corner is good or bad DC imaging quality often plays a very important role. Buying tripods actually hopes that the angle can provide a stable shooting state for some shooting conditions, but there are many situations that will result in unstable tripods. For example, it is a weightless tripod or a so-called portable tripod, in the opening angle When the imbalance or unrest, it is too much axial shaft rod, or the horizontal axle rod, etc., will make your corner angle shake. So the purchase of tripods is not as simple as ordinary users. Common tripod brands are not all tripods that they have to work like their manufacturers. In order to be able to stabilize the weight of the camera and the lens, the tripod must meet certain requirements. Like other merchandise, the price of a particularly strong tripod is also expensive. If the tripod is reliable, it must also minimize its own weight, and the price will be higher. Thus, only those structurally complex tripods made of special materials can meet the needs. At the time, a tripod made of polycarbonate is commonly used in professional photographers. Production of such tripods is currently made of Gitzo, Mamay, Slik and Jin Zhong (Velbon) and other manufacturers, this tripod is not only lightweight than the three-footed tripod using traditional materials, but also Large extent reduces the vibration. In terms of absorption vibration, wooden tripods and tripods made of polycarbonate doped with intensive fibers have a wonderful work, such a three-fastener manufacturer is mainly more than 100 years of history of Germany Berlebach. However, achieving maximum stability and lightweight is usually mutually exclusive. At the point of purchase of a tripod first, in the process of purchasing a tripod, not only consider its firmness and weight, but also considering its standing feet consists of several sections? How to adjust? Is there a ramp reinforcement when turned on? The performance of the central column should also be considered. These factors determine whether the tripod can easily produce the aforementioned shake while affecting the convenience of the operation. Regrettably, many tripod manufacturers seem to have ignored the feel of tripod. In the case of opening the tripod to the work, three different methods can be used: lock the rotary sleeve; fix the fastening screw; hit the lock with the thumb. However, what fixed tripod choice is not necessarily to fully reflect whether a tripod is efficient. Locking tripods with clamping methods do not necessarily be effective than tie screws. This depends on whether the tripod is easy to use in the wild.
By tightening the tripod, if the associated knob is not big enough, or the screw is inconvenient, then this tripod will be charged afterwards. Suppose the knob is placed in a vertical direction (ie, the horizontal direction of the thread), and some users will be treated in the direction of the rotation. For example, there are very few vendors' hearts with arrows to marke the knob. Many people will be screwed in the wrong direction when the knob is tightened, and they are not able to release the knob without the tools. If these knobs are placed horizontally, the user will not encounter trouble during tightening, because he will instinctively follow the method of guanjou, tighten the knob. In fact, how to pull out and fix the tripod center column, may be the problem of old talks. On this issue, the most correct and active method is to secure the center column with a ramp by the arms. As far as travelers often use a lighter tripod, simply loosen the clip, raise the tripod to the suitable height, and then reciprocate the tripod. If the locking device is located inside the leg, the user will cost the three-rack foot of the tripod to find this device, this method is more inconvenient. A preferred solution is to use a casing device above the shoulder of the tripod. There is a lack of friction locking devices to prevent the center column from suddenly falling in a tripod that suddenly fell suddenly in the clamping device. The more responsible tripod manufacturer chose to produce the production of ramp racks and gear devices to fix the central column, so that even if the locking device can be loosened, it can maintain the original height, and the way can be easily convenient. Adjusting the height, the degree of friction of such tripods can be adjusted without hindering the locking device. The central column of some tripods can be rotated, or completely removed, and then put it in, providing convenience for nearby, or used as a single frame. If the central column has a bubble level, it will be more practical because such central columns can be more accurately aligned on the rugged ground. If the device of the adjustment rack foot is located in "above", it is adjacent to the shoulder of the tripod, then the user can adjust the length of the foot. The last thing to say is that the stability of the tripod is maintained and the weight is a contradiction. The photographer who often clouds only accepts compromises, which maximizes the balance. Many professional photographers have a trick, which is the heavy object that can be found on the tripod to increase the weight of the tripod. In order to do this, they put a small bag in the photographic bag, filled with stone or sand, then put it on the lower end of the tripod center column, and because the weight is added, it can reach the tripod shake. Effect. Next, we recommend some common few fasteners who can consider in primary enthusiasts. Gitzo Jiexin 1126 G1126 Tube Foot Connection With a screw, a hex nut is tightened, and there is copper pad, nut and screws in the middle. This design is simple than 055cb and 190, and it is convenient to maintain, but the material must be better enough, so the connection block of Gitzo's three legs is smaller than the similar products of Manfrotto. G1126's pin lock is also a fixed Gitzo style. All rely, released and shrinks are more troublesome. When you start, it is not too habit, you will use a lot of strength to tighten it. It is actually not necessary, and it will be used for some power. Its pin is shrunk into the top of the top, which has almost the outer diameter of the outer diameter, which is almost the outer diameter of the outside, so it will not shake each other. The locking is the ride of a single electrical wood to the outside. Although G1126 is divided into four sections, only 12mm of the bottom section is only 12mm, but its thickness is 1.5mm, so it doesn't worry about it. Gitzo's design is the simplest, equally loaded tripod, which is the smallest, which should be "the Simple the Best".
However, there is no two-headed tip, and it is necessary to use it to take a little more patient. 2. Manfrotto Mandafu 190 Series Manfricad 190 Tripod MANFER 190NAT Manflu Figure 190 Series below Six products, 190 foot has three opening degrees, the center axis can be inverted; 290 foot is only one opening, medium The shaft is 10 cm than 190. 190nat is basically 190, and the center axis is detachable. The fastening mechanism on the feet is changed from the 190 screws like 055, which is green, and the appearance is green and is equipped with a foot nap. The 190 series is suitable; the weight is suitable; it is more light, it is easy to carry, and the length is basically around 50cm, and the weight is 1.7kg. The disadvantage is that the maximum increase in the biggest increase is not high; the load is generally, the machine or gun of the main body 120 is a little tasty; overall, and the sporty of Jiexin, this category The fastener is suitable for external shooting, compared to the 126 of the Jiexin has a certain advantage in price, load weight, height, etc., but there is no convenientness of the Jiexin, the degree of reliability may also be a bit less informed. New 190 series professional tripod (not connected to Yuntai) reference price 190D lightweight professional external shadow tripod silver 745 yuan 190DB lightweight professional external three-stroke black 798 yuan 190cl classic lightweight professional port three-handed silver 885 yuan 190CLB classic lightweight Professional external shadow tripod black 950 yuan 190PRO multi-purpose light velocational professional external shadow tripod silver 975 yuan 190PROB multi-purpose light velocity professional foreign shadow tripod black 1050 yuan 3. MANFER 055 Series 055 Series Frame Features 055 Series There are six products below. The diameter of the 055C center axis is different, the two sections, when it is low, the central axis can be inverted, and the three feet can be three openings, which can be equipped with a 055SPK foot nail. In addition to the weight, others are impeccable. 055 is basically 055c, the central axis can be inverted, but the diameter of the mid-axis is the same, detachable, not as good as 055C. Can be equipped with a 055SPK feet. 055nat is basically 055, and the appearance is placed in ink, suitable for wildlife shooting, equipped with a 055 SPK feet with a non-removable. The characteristics of the 055 series are high enough (1 m 7, 8), sufficient sport is too heavy (about 2.5kg), the equivalent is too large (about 60 cm), inconvenient to carry. Overall, the series of shelves is more suitable for indoor use. If you have a car, you can consider it as an external shoot. The new 055 series professional tripod (not connected) reference price 055A standard professional external shadow tripod silver 845 yuan 055AB standard professional foreign shadow tripod black 920 yuan 055cl classic professional foreign shadow tripod silver 1090 yuan 055CLB classic professional model Shadow tripod black 1150 yuan 055PRO multi-purpose professional foreign shadow tripod silver 1180 yuan 055PROB multi-purpose professional foreign shadow tripod black 1230 yuan 4. MANFER 390 Manflu Figure 390 advantages: cheap, light and disadvantages: After all, a penny is a package, the price is cheaper, the performance indicators must make some sacrifices, can only be used as entry-level. 5. Wei Feng 662 series This is a professional angle of professional, shrink height (mm) 690, model WT622 maximum tube diameter (mm) 25.5, and the maximum load height (mm) 1510, Minimum working height (mm) 625. Still is slightly stable, the price is also expensive, the reference price is 630 yuan.
